Tape the template to the.
How to cut a door handle hole.
2 screw hole boring template to door for drilling out the lockset holes.
Apply firm pressure as you drill the hole into the door making sure the hole saw is flat and not angled as it goes through the door.
This ensures you don t splinter the wood on the face of the door as you blast through drilling from just one side.
Place the chisel at a 45 angle and begin to chisel the.
Using a router attachment remove the wood between the pencil lines drawn on the door edge to create a mortise for the faceplate.
Drill halfway through from each side.
Take your time so you keep the drill perfectly.
Mark the centers of the holes unpack the installation instructions that came with the lockset and cut out the template with a pair of scissors.
Set the latch of the door handle into its hole and make distinct marks to.
With the large hole cut it s now time to drill the small 1 inch hole in the edge of the door.
Fold the template around the edge of the door at the height you want the knob which is usually in the center of the.
Chisel out the faceplate outline with a chisel and hammer.
Continued drilling through the opposite side until you complete the door knob hole in the door.
3 bore the doorknob hole through the face of door using a 2 1 8 inch hole saw.
Drill a pilot hole with a inch bit straight through the door.
Screw the faceplate into the.
Https amzn to 2utmcg0 door knob hole jig bimetal https amzn to 2e7v2oc forstner bit set 14 piece with case https amzn to 2zdjknp stanley chisel set htt.
How to chisel out a door lock plate.
Use a bevel edge chisel and hammer to square the corners of the mortise if the faceplate has square corners.
Mark the precise center top to bottom of the bolt.
Trace the handle s faceplate with a pencil.
1 transfer lockset location from old door to edge of new door.
You want to drill part way into one side of the door stop and then start to drill from the other side.
4 use a 1 inch hole saw to bore latch hole in door edge.
Place the template that comes with the lockset on the metal door.
Mark with an x the center spot for the doorknob.
Measure and mark a line along the center side to side of the jamb strip intersecting the line made in.
Fit the latch and faceplate into the door.
Screw a 2.
How to cut a hole for a door knob in a metal door 1.
