The spring to your right is a left wound spring and the spring to your left is the right wound spring.
How to decide left or right spring on garage door.
A left wind spring is usually placed on the right hand side of the door and right wind spring on the left side.
If you have only one spring on your garage door just remember that if the spring is on the left side of the bracket it is right wind and if it is on the right of the bracket it is left wind.
However they make sense if you follow the guidelines shown in.
The terms that describe the hinge position on a door are confusing.
In most cases you can determine the wind of your garage door torsion spring by using the color coded system on the cones at the end of the spring.
Usually most garage doors will feature two springs which are separated by a divider situated at the door s midpoint mainly.
It is difficult to measure the inner diameter of the torsion spring so you can look for the markings on the side of winding cones.
It is frustrating to order a door and find that the swinging door hinges are on the wrong side when it arrives.
These springs are most widely used in garage doors hence also referred to as garage door springs.
This helps you understand if the spring is left wind or right wind.
The garage door springs are often work under extreme stress conditions and may require replacement over time.
The left and right springs.
How to determine winding orientation left wound or right wound a general rule is that if the spring is marked with red paint then it is right wound.
Furthermore if the spring is on the left side when looking from within the garage it is right wound.
However before you go on selecting the spring you need to do a proper homework for selecting the right spring.
Look up at the springs from inside the garage.
That is unless it s a reverse torsion system which we are not going to discuss right now.
If you have a 2 spring system you should replace both springs and you can skip this step.
With most new garage doors there will be two torsion springs separated by a divider that s located at the midpoint of the door.
The only exception to this is if you have a door with outside lift bottom fixtures and the cables come off the fronts of the drums as pictured below.