How To Fix A Sliding Metal Closet Door Track

A dirty obstructed or damaged track can make a sliding closet door jump off its track.

How to fix a sliding metal closet door track.

To fix this issue first try vacuuming up debris and grime from the track with a crevice attachment. Lubricate the rollers but not the track because lubricant will act as a magnet for dust. Inspect the rollers and tighten them with a. Use an aerosol lubricant to lubricate all the door rollers.

Step 1 remove sliding door. Once secure release the door. Then retighten the screw close the doors and check the fit. Because sliding doors don t fold out the way bifold doors do they allow access to only half the width of the opening at a time.

See if the screws holding the guides down need tightening to be more secure. Loosen the set screw on the top bracket and slide the bracket slightly along the track to adjust the space between the top of the doors. Sliding closet doors operate on rollers that are positioned in tracks at the top jamb and floor allowing the doors to bypass each other in the tracks. Take one of the doors down by lifting it and angling the bottom toward you until the rollers clear the top track then pulling it toward you.

Remove a door by lifting and tilting the bottom out. If you have a sliding closet door that glides on a bottom track clean the track with a damp cloth to ensure smooth gliding. Then wipe it with a damp rag. If a roller is stuck unscrew and remove it.

To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks. When there is a problem with the track of your sliding door you can simply fix it by following a number of simple instructions. If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides. Fix it by gently grabbing the bent area with a pair of pliers or vise grips bending it back into place.

A closet door track that s bent inward prevents the door from sliding beyond the bend. Wiggle the door until the pivot snaps into the hole. The first thing to check is what type of rail system your sliding closet door uses in order for it to slide. Once the door is approximately under the hole in the track release the pivot.

Hold down the spring loaded guide on the opposite side of the other door panel and swing the door until the guide is under the track. Direct the part of the door towards you and take out the door from the closet. Parts for these doors are readily available at home centers hardware stores or online.