How To Fix Old Garage Door Spring

If it was opening too quickly move it to the next lower hole.

How to fix old garage door spring.

The general process is simple and safe. Test the spring by lifting the door about 3 feet. Install the new spring reinstall the pulley and reconnect the safety cable and you re done. Retest the door balance as you did in step 1.

Diy garage door repair and save money. Put on eye. If your garage door cable is at an angle or l. This system is unsafe and sh.

If the door remains in place the replacement was a. Adjust the springs on both sides of the door the same way. This video will show you how to repair a mis aligned garage door cable. Once the spring is free of tension remove from its track hanger.

Lubricate the spring with garage door lubricant then remove the clamp from the garage door. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. If the door was closing too quickly move the spring to the next higher hole on the bracket. Open the door to relieve the spring tension and secure it open with c clamps in the tracks.

Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. Leave the locking pliers in place and repeat the tightening procedure on the other side. Pull the cable as tight as possible before tightening the setscrews. Step 1 unplug the garage door opener and clamp the door to the track.

Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. This video is to inform you of a type of spring and bracket that exists on one piece garage doors with a jam pivot style design.