Step 2 tighten screws.
How to fix sliding closet doors.
Step 5 replace.
Use an aerosol lubricant to lubricate all the door rollers.
To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench.
When sliding closet doors are working properly they give you effortless access to your clothes shoes and furnishings.
If the rollers are damaged install replacement rollers available at home centers.
Raise it just enough to clear the track and roll smoothly.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
To fix this issue first try.
A dirty obstructed or damaged track can make a sliding closet door jump off its track.
Push or pull the top of the closed door to align its edge parallel to the frame.
Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws.
Loosen every single screw to ensure that you don t miss one and crack your.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
Open the door and then loosen the setscrew for the top bracket slightly with a screwdriver.
Step 1 clean the track.
If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides.
Unlike entry doors sliding closet doors rarely have a bottom track.
How to fix sliding closet doors.
To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.
Step 3 fix dented track sections.
Loosen the screws at the top of both doors.
The first thing to check is what type of rail system your sliding closet door uses in order for it to slide.
Step 4 tighten the overhead track.
Even if you have brackets on the bottom of your door they re probably just connected to your wheels.
Close the door to check for smooth operation and to see how the doors meet.