How To Fix Stripped Screws In Door Hinge

The wrong way is a temporary fix not cool.

How to fix stripped screws in door hinge.

I have a very heavy 1930 s bathroom door that i have tried all the tricks to fix and it keeps pulling the screws out of the top hinge. This last time it even pulled out the screws from the bottom hinge at the frame. Thank you for the pictures. This will wedge into the head of the screw and pull it.

Remove the screws that hold the loose hinge leaf to the door jamb. How to fix a stripped screw hole. Open the door wide and insert a wedge under the bottom outside corner to level it. Easy fixes may also be ineffective in situations where a heavy door has caused hinge screws to strip out the wood on the edge of the door or the door frame.

To remove the loose wood screw drill out the stripped hole and glue in a dowel the same diameter as your drill bit. Then you ll need to fix the stripped area. We ve all had the problem of a screw getting pulled right out of a hole and stripping out the wood that should be holding it. You can then drive the screw into the dowel to secure it.

Then glue and cut the dowel so it s flush with the edge of the door or hinge. Take your screwdriver and remove the others screws that hold the hinge onto the door. If the screw of the hinge is the part that is stripped you will need to get a stripped screw remover from a hardware store. My last ditch effort is to try this fix with the dowels.

Due to the design of the doors a prefab door would stick out like a sore thumb. On my cabinets the door actually fell off because a chunk of particle board fell off. Then bore out the stripped holes. How to tighten stripped hinge screws.

If the hinge and jamb are painted cut the paint around the leaf with a utility knife swing the leaf away from the jamb. I will repair that in a separate instructable once the door hinge is out of the way carefully drill out the hole where the screw used to be. In these situations the best repair method is to drill out the screw hole with a 1 2 inch bit then fill the enlarged hole with a glued 1 2 inch hardwood plug or solid hardwood dowel. Step 3 remove the stripped screw.