Trim the letter layer close to the lettering at the top and along each side.
How to hang letters on wall straight.
Using a tape measure find the center of the area that you want to hang your letters.
We re here to show how to hang wall letters with adhesive hardware and non marking hanging strips.
Hanging wood letters on the wall.
Use a level to make sure your tape is perfectly straight.
Loop the end of the rope and tie to slide onto the head of the screw.
Use painters tape to mark center.
Hold your letter up against the wall and adjust it until you think.
Mark the spot where you want to hang the letter.
Then use a screwdriver to make a hole where you want the nails to go.
Mark on the tape exactly where the nails or screws need to go.
Position the letter layer on the board.
Attach two small screws to the back of the letter.
How you hang wall letters depends on the size weight and material of the lettering the mounting surface and if you can drill holes or not.
Stick a piece of tape across the letters.
Take your marked tape and place it on the wall where you want your pictures to hang.
Securely personalize walls with custom letters created just for you.
Hold your straight edge against the wall at the level that you want the bottom of your.
Then i eyeballed the blue tape where i wanted to be in the frame.
I hung the frame on the wall so i could see where to place the blue tape.
Cut paper strips the width of the side margins and apply them to the board with glue stick.
You can see the full instructions here.
For heavier letters grab double sided mounting tape.
Choose an adhesive based on the size and weight of the letters.
Here s how you hang letters on a wall in one easy step with just one piece of tape.
Stick painters tape to the back of a long straight edge make sure it is very light weight.
Alternately a d ring can be used by attaching to the back of the letter with included hardware and tying the rope through the ring.
Most of our customers prefer hanging wood letters with hanging strips or double sided mounting tape.
You can also make a diy approximation by driving a nail through the bottom of a paint stir stick.
For a frame with two brackets on the back place a piece of painters tape across the back.