How To Hang Wall Art On Plaster Walls

How to hang on plaster walls with a picture hanging system the ideal solution for hanging pictures on plaster is to use a picture hanging system like the all in one click rail cable hanging kit.

How to hang wall art on plaster walls.

Turn the screw to mushroom the slotted sleeve against the back wall surface. Check the small capsule of liquid along the center of the level. Drill a hole the same diameter of the plastic plaster anchor insert if you are hanging in area without a wall stud. Press the mount flat against the wall then set the level on top of it.

How to hang lightweight pictures on plaster walls. Learn a very simple drill free way to hang pictures and other things on hard plaster sheet walls with ease. This part will be easier if you have someone to hold the mount up for you. Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail.

For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done. Next drill a hole into the mark using a 3 16 drill bit before removing the piece of tape. Use a carpenter s level to level the mount on the wall. Take care not to overtighten.

If your room has this you can simply drive a screw through the wood and use this to hang things. It also prevents mildew that can form in the porous plaster. Some older plaster walls have a thin strip of wood that runs around the perimeter of a room usually between 1 inch 2 5 cm to 1 foot 30 cm below the edge of the ceiling. Use a picture rail if you have one.

Wood lath plaster walls that are commonly foun. Perform the cleaning using warm water and a mild liquid dish soap. To hang a picture on a plaster wall make a pencil mark where you want to hang the picture then cover the mark with a small piece of painter s tape. If the mount is straight the bubble in the liquid will stay in the center.

This system works by simply installing a rail along the wall and pictures then hang from cables attached to the rail and are fastened with hooks. Clean and dry the wall. Seat the round flange flush with the wall surface by tapping the screwhead. Cleaning ensures that there is no oil dirt or moisture that could prevent adhesive glue from clinging to the wall.

Then hammer a wall anchor into the hole until it s flush with the plaster.