How To Install A Lock On A Hollow Door

Once inserted a small key is used to open the anchor which spreads out interior brackets to clamp the collar of the anchor against the door face like a toggle bolt.

How to install a lock on a hollow door.

Attach the interior part of the deadbolt lock by inserting the two provided long screws through the interior plate the two screw holes in the bolt and into the exterior side of the lock. Using the original hinges if possible place the hinges and make sure the hinges are level with the door. Tighten the anchor screws with a phillips head screwdriver. Hand thread the screws then tighten them using a screwdriver or power drill.

If mounting into a solid door simply secure the hook to the door with retaining screws. Step 1 find the lock block. This means that they are not solid wood and this might pose a problem with the strength of the deadbolt. To mount anything into a hollow door requires special hollow door anchors.

Use a sharp point to mark the centers of the two hole positions for the lock cylinder through the face of the door and the latchbolt into the edge of the door. Measure from the edge of the door to the center of the circle on both sides to make sure the. Always use bolts instead of. Use the drill to screw pilot holes and attach hinges to the door.

Snap on the decorative outer plate. These plastic anchors fold flat to fit inside a pilot hole drilled into the door. How to install a deadbolt into a hollow core door. Decide where to install the deadbolt on the door.

Place one of the deadbolt plates on the door to figure out exactly where it should be. Use masking tape to affix the template at the proper position. Scrape away remaining wood. Use the chisel on a low angle to prevent digging deeper than necessary.

Mark the center of the holes for both the lock cylinder and latchbolt. This section will either be built in on the side or will run from the top to the bottom of your door. A lock block is a solid piece of wood that is pre built into hollow doors so that you have a solid section of wood to drill your lock into. Step 4 install door knob and latch.

Insert the anchors into the holes in the door and tap the top of the screws as necessary with a hammer until the back of the hook is flush against the door.