How To Make A Patio Roof

It is almost similar to the first method but to make the patio roof a little bit higher you will need to remove the house gutter and place the back channel a bit higher.

How to make a patio roof.

If necessary use a sliding bevel to determine angles needed where the rafters will meet the ledger board. Louvered patio roof ideas. Locating and mounting the ledger is normally a fairly easy process. Put a cement footing at each corner of the intended patio roof space and attach anchors to each footing.

Building on an existing deck. The difference comes in with the type and installation of the beams. Patio cover plans building. Attach the rafters attach 2x6 rafters to the house with joist hangers and or supported by the ledger board.

Because the gutter is removed you will need to install transfer flashing from the roof of the house to the patio. Check local building code to see if you can attach a patio roof directly to your deck. The existing concrete slab creates the angled floor of the patio and the roof line is built to match it and the odd lines of the house. When you are building a patio cover off of an existing roof or wall you must take all of your measurements from the point at which the patio roof will attach to the existing structure not the outside of the slab.

The existing slab can vary considerably throwing off crucial measurements. Step 2 construct the vertical posts. Then draw a chalk line along the outlined area for placement guidelines. A louvered patio roof is similar to a pergola.

Then there are wooden beams that are evenly spaced over the frame to create the roof. Using corrugated metal also allows me to reduce the degree of slope or roof pitch needed to a mere 10 percent or a 1 to 10 pitch. Measure the area where you want to install the patio roof cover. One side of the patio roof line will match the angles of the house while the other side of the roof line is straight.

This meant the patio cover could start at the edge of the house s roof at a height of eight feet and slope down to seven feet leaving a clearance of more than six and a half feet between the lowest part of the frame s headers and the ground at its outer edge. The ledger should be attached before the foundation is built for a deck patio roof posts and other structure. Blow out the dust fill the hole with epoxy and insert the rod to the required depth. Let the epoxy set leaving it overnight will assure that it is rock solid and then add the anchor bolt anchor washer and nut and tighten.

Both have posts or columns that support a frame. The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters.