How to install gutter flashing.
Install apron flashing gutter.
If your home center or hardware store doesn t sell pre bent flashing ask an aluminum siding contractor or local sheet metal fabricator to bend some for you.
Second step flashing needs to extend 8 to 14 inches above the shingles according to the national roofing contractors association nrca.
Protects fascia board finishes the roof line and guides run off into gutters.
30 degree white aluminum.
When it comes to gutter apron and flashing installation there is only one indianapolis area gutter apron and gutter flashing installation specialist that you need to rely on the most.
Drop with 1 4 in.
A couple picture are attached are there the proper aprons.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
It is put under the shingles of an attic to flow water directly into the gutter.
If this is a repair job the siding must also be removed and replaced with the flashing.
Climb up the ladder and pull back the shingles at.
What is a gutter apron.
Add all four sides together for the.
A gutter apron is used where shingles are not far enough from the edge of the gutter.
The gutter lip and the apron lip go together so essentially you are extending the back of the gutter by 1 11 4 high.
Nailing edge 1 3 4 in.
With gutter replacement you can prevent water from running behind your gutters by installing a metal gutter apron flashing under the shingles and over the back edge of the gutter.
A gutter apron is installed on the corners above roof decking.
A gutter apron is a long piece of metal fold that starts under the first course of shingles and hangs over the sheathing of the roof.
Is it a proper install.
Position a ladder on the ground at any corner of the house.
Measure all the sides of the roof line of the house with a tape measure and record the measurements.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
The flashing helps guide run off away from shingles and into the gutters.
First step flashing must be installed before the siding so that the siding can cover the top of the flashing.
Gutter apron a specialized drip edge designed to direct water into the gutter system.
While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.
At ryan they also have flashing called a gutter apron which actually is about 1 11 4 which and has a lip also on it.
Home centers sell rolls of 6 in.
Irestore roofing restoration are the indiana experts in the gutter apron and flashing installation industry.
Gutter apron is installed over the roof edge and hangs in the gutter.
Once the apron s in place fasten it with sheet metal screws.
Install by nailing under shingles.
White aluminum roof apron flashing.
While a drip edge is about 2 1 2.
