Measure the length of the porch roof joint to determine how much flashing you will need.
Install flashing rood to awning.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Begin by removing the shingles at the affected area and removing old flashing if present.
If siding on.
Before we install the end wall flashing we have to apply tape sealant to the top of the z trim so that there s a water tight barrier between the end wall flashing and the top of the z.
Position the flashing with the lower edges atop the carport roof panels along the transition.
Less than a minute.
Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed.
Place the flashing between the joint of the house and the roof.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
A magnetic torpedo level will provide even mounting brackets and adequately adjusted roof brackets.
Nail the flashing securely in place using roofing nails.
After installing the brackets the installation process of the awning can vary based on the awning itself as well as the type of mounting.
The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.
Smart awnings with sensors.
Also take time to properly seal all edges of the mounting brackets with high quality silicone sealant.
Retractable awnings retract or unfurl in less than a minute by hand or automatically via remote control wall switch smartphone tablet timer or key switch.
Prepare the area where you will install the roof flashing.
Nail the upper edges of the flashing to the roof sheathing where the shingles were removed with 6 penny.
How to install porch roof flashing.
