Obviously the further up the wall a flashing extends the greater the resistance to water intrusion.
Install flashing roof meets wall.
Click to enlarge make sure the sheathing wrap overlaps all step flashings.
This illustration shows proper flashing at a headwall condition.
Nail it in place with two nails one.
Ensure it sits flat and extends at least 8 inches above the shingles.
Likewise a 10 wide flashing will result in a 5 inch wide roof deck flange and a 5 inch vertical flange.
Flexible flashing tape seals the eave to the wall.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia meets it.
Headwall flashing should extend up behind the exterior wall covering and down over the roof covering material as you see here.
Then set the piece down.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Where snow buildup is likely add a wide band of peel and stick membrane lapped over the step flashing but under the sheathing wrap.
To install the roof wall flashing above the builder bent the top edge of the flashing into a 90 degree lip about 2 cm in width.
Bend it back so that it overlaps the corner flashing.
Begin by removing the shingles at the affected area and removing old flashing if present.
Step flashing protects the gap where roofs meet walls by weaving into the roof shingles.
Even if one piece of step flashing fails the flashing and shingle below it start the process over again.
That lip is then set into a reglet or groove in this case cut into the mortar joint of the brick wall above.
Install a reverse peak flashing for the other side of the roof so the two.
I cut the tape so that it laps onto the housewrap above and 3 in.
Where a slope roof meets a sidewall slip the upper legs of the step flashing under the sheathing wrap see illustration.
Bend the roof edge of the flashing down over the peak and nail the wall side to the sheathing extending past the peak.
At the bottom of the roof water needs to be directed.
Step flashing redirects the water back onto the shingle.
Hammer one nail to the.
A 5 inch wide flashing will result in a 2 1 2 roof deck flange and 2 1 2 vertical wall flange.
How to install step flashing with a wall corner step three.
How to install roof flashing against a wall.
I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall.
This is true no matter what type of roof covering material is installed.
Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
