Install Gutter Apron Over Drip Edge

Gutter aprons take on an additional role by hanging down an inch or so into the back of the gutter to prevent water from dripping or splashing behind the gutter.

Install gutter apron over drip edge.

While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter. It is put under the shingles of an attic to flow water directly into the gutter. The design of your attic though can affect the installation process. Gutter aprons take on an additional role by hanging down an inch or so into the back of the gutter to prevent water from dripping or splashing behind the gutter.

A gutter apron also known as l metal is installed above your roof decking and sits over the edge of your gutter. Then it is slipped under normal drip edge. It installs on the roof edge at the eaves and hangs into the gutter. The hangers have a slight angle to them and actually you screw through the apron portion right into the fascia just works out that way because of the angle of the hanger.

Installing a drip edge or a gutter apron is not as difficult as one would expect. If your attic design has a lot of curvy edges and sides installing a gutter apron would be a preferred option. Home centers sell rolls of 6 in. What is a gutter apron used for.

If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter. While a drip edge is about 2 1 2. Used to direct water into the. The gutter lip and the apron lip go together so essentially you are extending the back of the gutter by 1 11 4 high.

A gutter apron is installed on the corners above roof decking. A gutter apron is perfect for directing water into your gutters. This directs water straight into the gutter system and also protects your roof line from excess moisture. A gutter apron is a long piece of metal fold that starts under the first course of shingles and hangs over the sheathing of the roof.

A gutter apron is used where shingles are not far enough from the edge of the gutter. Use tin snips to cut the gutter apron flashing roll in two 3 in.