Install Recessed Lighting In Existing Ceiling No Attic Access

Watch the entire process step by step.

Install recessed lighting in existing ceiling no attic access.

Recessed lights commonly called can lights offer a pleasing finish to virtually any room and make for a reliable source of inconspicuous lighting. When the can is installed into the ceiling clamps on the side expand securing the fixture. Use an electronic stud finder to locate two adjacent rafters and mark a spot half way between them as the. The housings and trim themselves aren t that expensive i picked up some 4 halo retrofit can lights for about 17 each from lowe s and trim for about 20 each at home depot.

With a utility knife cut off 3 inches from the outer insulation jacket of each end of the electrical cable to expose the internal insulated wires and bare copper grounding wire. Unfortunately though a retrofit installation for those of us without attic access can also get pretty expensive if you hire someone to do the work for you. If necessary go into the attic and make sure there are no wires pipes or ductwork behind the proposed opening. Remodeling recessed lights also found on amazon pencil.

Its wires are held inside an electrical box that is connected to a metal light can. But some homeowners may be reluctant to install them if they don t have access to attic space above the room where they would like to have the can lights installed. Cut the cable with wire. Remodeling recessed light housing is the required model for the project.

Run electrical cable through the ceiling from the recessed light hole over to the light switch hole. Insert the electrical cable into the cable clamp on the remodelling recessed light housing. Mark the spot on the ceiling where the recessed lighting fixture is to be installed. How to install recessed lighting even without attic access materials needed.

Pull the end of the cable out of the wall by 6 inches with fish tape. Recessed can lights are flush mounted with the ceiling.