Installation Of Rpn Rake Steel Roof Trim

We will position this on the roof so that we can fasten it to the roof deck and install the rake gable trim.

Installation of rpn rake steel roof trim.

The rake trim is installed over the roof panel and over the wall panel using self drilling screws and sealant tape. Install the roofing screws vertically along each rib in the panel. Step by step instructions for installation of gable and rake trim on an exposed fastener panel. Additional screws should be placed 12 on face staggered from top screws.

Lap screws should be placed 12 on center hitting the high seam of roofing corrugation. Tape and to fasten the rake every 6 to 12 up the slope of the roof with the appropriate screws. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. Resulting in a uniform edge rake trim terminates the roof panel at the end of the roof to the gable end wall panel gieseke says.

The z trim has paint on one side and primer on the other. Fasten gable trim with x inch metal to metal lap screws. Do not place screws 12 from the ridge of the roof until ridge cap is installed. To prevent penetration of water insects and debris at the ridge outside closures are inserted between the ridge cap and the top end of the panel.