Installimg Aluminum Siding Over Stucco And Wood Panels

Aluminum fascia goes directly over the wood fascia and has a lip at the bottom that laps over the outer edge of the installed aluminum soffit.

Installimg aluminum siding over stucco and wood panels.

You can change the appearance of the stucco wall surface by covering it with a wall of siding. To install siding over the stucco you ll have to first attach furring strips to the exterior walls. Prep the wall to keep bits of stucco from falling between the new siding and the old stucco scrape away loose or crumbling debris from cracks in the stucco and roughly patch the cracks with mortar. The most important thing is you want the kind of siding that has drain channels in the back of it so any moisture gets in there it ll drain out the bottom.

New siding can be installed over existing exterior coverings in some cases. Installing siding over existing stucco does not give us a chance to identify underlying rot issues so if you have any concerns a full removal could be your best bet. Use a trowel to apply the first layer of stucco to a depth of approximately inch. How to install siding over stucco walls.

Measure the width of your wood fascia to determine which width to buy. Summit prefinished siding is designed for lp smartside products to provide your home with exceptional durability and beauty. Beyond removal to assess and repair rot damage sections of the wall where stucco is bulging or otherwise out of square may need to be removed in order to get an even fastening. For homes with stucco exteriors a framework of wood furring strips must first be installed to create a level surface which suspends the outer layer of siding over the inner layer so that water cannot settle between the two and cause rot and erosion.

While installing vertical metal siding is similar to installing horizontal siding there are a few differences you ll want to keep in mind. On this particular job the home already had aluminum siding. Fortunately with the right tools and preparation putting vertical metal siding up on a building can be a smooth and simple process. Follow the directions on the ready mix stucco to prepare the material for application.

It s attached to the steel siding and then it s covered with a stucco like material these foam panels that are attached first and it s covered with it. Vertical metal siding can give a building a modern sleek appearance. Stucco adorns the facade or interior walls in many homes. Mist the layer with water and allow the stucco to cure for several hours.

6 and 8 in. It comes in two standard widths. The client had a tight budget and just wanted to patch in new siding to match the existing siding.