Installing Hardiplank Lap Siding

Into the solid wood wood sheathings like osb and plywood count toward the 1 1 4 in but soft sheathings like.

Installing hardiplank lap siding.

Blind nailing preferred installation james hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above. Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation. Protect edges and corners from breakage. Installing hardiplank lap siding.

James hardie is not responsible for damage caused by improper storage and handling of the product. Hardieplank lap siding. Hardieplank lap siding is not just our best selling product it s the most popular brand of siding in america. How to install hardie board lap siding preparation.

From the ends of the plank. Installing siding wet or saturated may result in shrinkage at butt joints. After removal of the old siding new house wrap should be installed to provide a water barrier between the. From the top edge and no closer than 3 8 in.

When taking planks from the pallet for installation avoid repeating the texture pattern by working your way across. The first course of any wall should be installed over a 1 4 lath strip to ensure a consistent plank angle see figure 1. N nail lengths should be chosen so they penetrate a minimum of 1 1 4 in. What are some helpful james hardie lap siding installation tips.

Measure up from the ground 6 inches plus the width of one plank at a corner and make a. Down from the top edge at each stud no more than 16 in. As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. Carry planks on edge.

Optionally install the lap siding with a maximum 1 8 gap and caulk the joint see detail at right. Use 6d or 8d galvanized or stainless siding nails and install a single nail about 1 in. Fasteners shall be installed between 1 in. The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going.