Installing Hardiplank Siding With Screws

The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going.

Installing hardiplank siding with screws.

Fasten hardiebacker sheets with proper nails or screws as listed in materials required in the backer installation instructions every 8 around the perimeter and all supporting studs. Optionally install the lap siding with a maximum 1 8 gap and caulk the joint see detail at right. Fasteners shall be installed between 1 in. Use a number 8 1 1 4 inch long by 0 375 inch wide hd ribbed wafer head or equivalent screw on steel studs.

Minimum standard panel design size is 12 x 16. From the ends of the plank. The term applies to a nailing screwing method for joining hardieplank planks to hide nail or screw fasteners. Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation.

We are installing hardiplank on our new oceanfront home in a high threat hurricane area and in the process of getting bids for the job i have had at least one contractor suggest that i should consider installing the siding with screws rather than the more common ring shank nails. Corrosion resistant screws ribbed bugle head or equivalent no. James hardie building products provides installation wind load information for buildings with a maximum mean roof height of 85 feet. James hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above.

Keep fasteners between 3 8 and 3 4 from sheet edges and 2 in from sheet corners. For information on installations above 60 feet please contact jh technical support. The first course of any wall. From the top edge and no closer than 3 8 in.

Install hardiplank siding with joints butted in moderate contact.