How To Get Into A Locked Door

Ideally you should consider drilling your lock after you have exhausted all other bypass methods to unlock a door.

How to get into a locked door.

Twist the wrench to see which way has more give. When you insert the bent paperclip stick the straightened paperclip beneath it and move it around. Unless you plan on. Lift your knee straight up and let your lower leg be pulled along with it.

Drilling a lock is a form of destructive entry. Kick the lock on the door with the bottom of your. There s no universal standard for which way a key turns to unlock a door. Lift your dominant leg at the knee.

If the locking mechanism is a latchbolt the kind of bolt that is spring loaded and has one angled edge and the angled edge is facing away from you you can hook it with a wire hanger. If you hear a click the lock is disengaged and the door should open freely. Put them in a tight chokehold drag them over to the. Gently insert the screwdriver s flathead into the door knob s slot then turn it counterclockwise.

Apply pressure on the lock using knife and push it back in the door. The head of the screwdriver must be small enough to slip inside the slot of the outside door knob. Make sure that it is placed on the opposite end of where the key s teeth grooves that move the key pins would go. Insert the knife between the space in the door and the frame where the lock is situated since knives are thin it should easily slide in between the lock and the frame.

After some wiggling your lock will hopefully open. Stand in a solid stance. To open these locked doors you ll need to take a nearby enemy hostage by sneaking up on them or knocking out their legs with a bullet or two. Squarely face the door with your feet roughly shoulder width apart knees slightly bent.

Once you ve hooked the doorknob take hold of both ends of the cable and pull back and forth and try to turn the doorknob. Turn the key both directions. Push or pull the door as you turn the key. You may also need to tilt the knife a little till you find the suitable angle for moving the lock.

This too can take a few minutes but just push on the door a little and be patient and you should be able to turn the door knob and be back in your room. Opening a jammed lock 1. Bend one of the paperclips and fold out the other one as straight as possible. The tools required for drilling a lock are an electric or battery powered drill a drill bit a suitable lubricant and.

Be careful not to exert too much pressure here.