A drip edge is a metal flashing that is installed at the edges of the roof to help control the flow of.
Installing gutter apron and drip edge.
How to install a drip edge slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
Home centers sell rolls of 6 in.
When collecting estimates for gutter or roof repairs it is helpful to know the terminology and what exactly you are getting.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Similar to a drip edge a gutter apron is a long piece of metal folded at about 120 degrees.
Use tin snips to cut the gutter apron flashing roll in two 3 in.
A gutter apron is used where shingles are not far enough from the edge of the gutter.
It installs on the roof edge at the eaves and hangs into the gutter.
Used to direct water into the gutter system.
If it doesn t pull the drip edge out slightly from under the shingles.
Two such terms that the average homeowner might run into is a drip edge and a gutter apron.
The gutter lip and the apron lip go together so essentially you are extending the back of the gutter by 1 11 4 high.
Install the drip edge tightly against the edges of the plywood sub roofing so that it hangs down over the fascia.
While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.
What is a drip edge used for.
A gutter apron is installed on the corners above roof decking.
Use a 3x3 that goes behind the gutter then seal the back of the gutter to the 3x3 with high quality tri polymer sealant geocell 2300 with drip edge or gutter apron above the gutter the melting water will go under either enter your soffit and run down your bearing wall it d be like you wasted your money on the ice water shield also make sure.
Then it is slipped under normal drip edge.
What is a gutter apron used for.
Nail it in place with 1 inch roofing nails.
Gutter aprons and drip edges.
Cut a length of drip edge when needed with a pair or tin snips.
Make sure the outer edge extends over the gutter.
The hangers have a slight angle to them and actually you screw through the apron portion right into the fascia just works out that way because of the angle of the hanger.
It is put under the shingles of an attic to flow water directly into the gutter.
Overlap joints where two pieces meet by about 1 inch.
It starts under the first course of shingles and hangs over the roof sheathing.
