How To Install Door Lock Strike Plate

Then reattach the strike plate.

How to install door lock strike plate.

Lastly screw the strike plate into place on the doorjamb. The strike will hold the bolt in place keeping the door locked until the bolt is retracted using a key or thumb turn. The mortise needs to be as deep as the strike plate is thick. Many smart locks have a flaw that makes them vulnerable to break ins.

Whether you re installing a lock plate also called a strike plate for a deadbolt lock or a standard lockset you first must install the lock or lockset onto the door following the manufacturer s instructions. So take the time to mark and cut carefully. To install a door strike plate you must first mark the location of the plate on the door jamb. Knowing how to cut a mortise is essential for installing a deadbolt lock.

Tape the strike plate back up to test that the hole is deep enough to receive the latch. Using the technique described in steps 6 and 7 chisel out a mortise as deep as the strike plate is thick. Have a door out of alignment due to settling. Install the strike plate and test that the deadbolt is working properly and that the hole in the door jamb is deep enough to accept the entire bolt.

If it s not remove the strike plate and chisel out more wood until it s deep enough. Need to drill a new hole really close to the original one. The strike is installed on the door frame and contains a hole that catches the latch or bolt that extends from the lock. Step 6 mounting the new strike plate.

To allow proper clearance for the lock to operate most strike plates are recessed into the door frame. Close and open the door to be sure that the latch is catching properly. The stripped hole repair kit from king s original ha. Drill pilot holes for the strike plate s two screws with a 3 32 inch bit then screw the plate in place.

Hold the strike plate over the mortise and score its outline with a utility knife. What you didn t know you could adjust a door strike. Fortunately cutting out this mortise isn t nearly as difficult as it sounds. Once you have reached the necessary depth remove the tape.

You ll need to cut a mortise a small shallow recess in the wood of the door and doorjamb for the latchbolt and strike plate to rest. Next a hole must be drilled in the jamb to accept the door lock bolt.